Baxi EcoBlue Heat Manuel de démarrage rapide télécharger pdf (Page 49)

7212435 - 02 (08/14) EcoBlue Heat 49

Maintenance 10

10.2 Standard Inspection and Maintenance Operation

When performing any inspection or maintenance

personal protective equipment must be used where

appropriate.

1. Unscrew the two screws located on the lower front panel

(Fig. 36).

2. Slide the lower front panel forward and hinge down or

remove (Fig. 37).

3. Unscrew the two securing screws on the front panel. Remove

the front panel (Fig. 38).

4. Visually check for debris/damage and clean or replace if

necessary the following:

a) Check the water pressure (sealed systems)

b) Check the flue pipes and air supply pipes for leaks

c) Check and clean (if necessary) the condensate trap

d) Check the ignition electrode (replace if necessary)

e) Check the combustion

f) Complete the relevant Service Interval Record section of

the Benchmark Commissioning Checklist at the rear of

this publication and then hand it back to the user

WARNING

Ensure that the boiler is cool.

Ensure that both the gas and electrical supplies to

the boiler are isolated. Electrical isolation can be

checked at the electrical test point.

CAUTION

During inspection and maintenance operations,

always replace all gaskets on the parts removed.

Use only original spare parts that are intended for

use with this type of boiler.

Fig. 36

Fig. 37

Fig. 38

Electrical Test

Point

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 63 64

Pas de commentaire

Baxi EcoBlue Heat Manuel de démarrage rapide Page 49