Baxi EcoBlue Heat Manuel de démarrage rapide télécharger pdf (Page 33)

7212435 - 02 (08/14) EcoBlue Heat 33

Before Installation 5

5.3.9 Flue/Chimney Trim

1. The flexible flue trims supplied can be fitted on the outer and

inner faces of the wall of installation (Fig. 14).

5.3.10 Terminal Guard

1. When codes of practice dictate the use of terminal guards

(Fig. 15) ‘Multifit’ accessory part no. 720627901 can be used

(NOTE: This is not compatible with Flue Deflector referred too

below).

2. There must be a clearance of at least 50mm between any

part of the terminal and the guard.

3. When ordering a terminal guard, quote the appliance name

and model number.

4. The flue terminal guard should be positioned centrally over

the terminal and fixed as illustrated.

5.3.11 Flue/Chimney Deflector

1. Push the flue deflector over the terminal end, it may point

upwards as shown, or up to 45° either way from vertical. Secure

the deflector to the terminal with screws provided (Fig. 16).

5.3.12 Flue/Chimney Accessories

For full details of Flue Accessories (elbows, extensions,

clamps etc.) refer to the Flue Accessories & Fitting Guide

supplied in the literature pack.

Flue Deflector

Fig. 15

Fig. 16

Terminal

Guard

WARNING

SUPPORT - All flue systems MUST be securely

supported, a MINIMUM of once every metre and at

each change of direction. It is recommended that

every straight piece is supported irrespective of

length. Additional supports are available as

accessories.

VOIDS - Consideration must be given to flue systems

in voids and the provision of adequate access for

subsequent periodic visual inspection.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 63 64

Pas de commentaire

Baxi EcoBlue Heat Manuel de démarrage rapide Page 33